Skip to main content

The making of a Silk oak open hollow vessel

The making of a Silk oak open hollow vessel. This piece started at about a good 9" log. I turned past the sap wood and the check/chacks

  The process of hollowing. The tricky part here, is that this vessel is so small and about 11" deep, to the base.


At this point I started to add colors, of dye. The trick here is to sand as much of the dye off as your patience will allow, you can always add more, as I do all the time, until I have something I like.
Labels:

Comments

Post a Comment

Popular posts from this blog

The making of a sphere jig for the wood lathe, on the fly.

Aluminum block on wood lathe.  My goal is to create a sphere jig, (sounds so much better than a ball jig). First things first, I bought the One Way drill jig at the symposium, in Phoenix this year, with the thought of mounting a router. I never thought I would be using it on aluminum. This picture shows my first attempt at making a "T" washer to use to bolt the sphere jig. The second picture has the jig repositioned, parallel to the bed ways, I like this position much better, as it allows me to plunge to the depth I require. Then I reposition it, toward the center by + 1/8" or so. Also you need to play with the speed of the lathe. I believe I was some where around 250-300 rpm. This piece is a cut off, I never measured the thickness. it is just thicker than the 2 enclosed bearing I plan to mount. Also it's thicker because I wanted to add girth, to ensure more rigidity. This picture show the center knocked out. I used the router to go as thin a...
3 comments
Read more

Turnings. A wood adventure

Post a Comment
Read more

Home made deep hollow system and bar

Post a Comment
Read more