Another good turn, a walnut adventure...

Figured walnut. This is second piece, and I am going to attempt to create a match to the first one. The first is an open vessel. This one I am attempting to top it off with a lid and an inlay of olive wood.
I added a coat of shellac, just to seal it, and protect it in the next phase. when I add a perforated ring dyed black.

Sanding

Fitting the lid.

Gluing olive inlay to lid.

Hot melted to turning block.

cut out on band saw.

cut out to except inlay

Reverse lid, to create inlay mortise.

Olive glue up

Add tape to stop glue, and to line up grain

Comments

The making of a sphere jig for the wood lathe, on the fly.

Aluminum block on wood lathe. My goal is to create a sphere jig, (sounds so much better than a ball jig). First things first, I bought the One Way drill jig at the symposium, in Phoenix this year, with the thought of mounting a router. I never thought I would be using it on aluminum. This picture shows my first attempt at making a "T" washer to use to bolt the sphere jig. The second picture has the jig repositioned, parallel to the bed ways, I like this position much better, as it allows me to plunge to the depth I require. Then I reposition it, toward the center by + 1/8" or so. Also you need to play with the speed of the lathe. I believe I was some where around 250-300 rpm. This piece is a cut off, I never measured the thickness. it is just thicker than the 2 enclosed bearing I plan to mount. Also it's thicker because I wanted to add girth, to ensure more rigidity. This picture show the center knocked out. I used the router to go as thin a...

Gallery Book Please fill free to click on link and send any suggestion you might have before I publish this book. let me know what you think.

Osage Orange Chalice, the making of, from green wood

Well I just could resist the attempt to complete this chalice. All was great until I got it home and notice the smallest of cracks at the rim. It must have a cured while I was finishing the bottom. I see another attempt in my future. Turning wet, I soak it with shellac and alcohol. I then turn the interior and coated it with a blend of beeswax, carnuba and walnut oil. I am told that this is the correct finish for a usable goblet or cup. I then turned the upper portion outside, and inlaid some malachite, turquoise and a couple other minerals. I the sanded and sealed the outside with shellac and then the beeswax mix. Turned out pretty good. I then started the base. Using a rotary tool I carved some decoration just below the cup section. I then used a wire brush attached to the cordless drill. I then mixed some 5 min epoxy with green alumilite dye. Sanded all down to just leave the deepest crevices. I also added some gold dust, (very little), I painted the abstract leaves with...

MIND OF A BLACK WOODWORKER IN ARIZONA

Search This Blog